Water Heater Pros Flush Kit

Every water heater has an anode rod. Water corrodes the inside of steel tank water heaters. The anode rod sacrifices itself to protect the tank. As it deteriorates it should be replaced about every 3-5 years or the tank will corrode and eventually leak. Check your anode rod every 3 years, as the anode rod's life depends on a few variables, including water quality, hot water use, hot water temperature, and tank quality. The Water Heater Pros flush kit will help avoid early tank failure, and in most cases with routine maintenance will double your water heaters life cycle. The segmented design allows for easy replacement in tight overhead spaces (14” needed). The anode rod can be cut in length to fit short water heaters. The anode rod is made of environmentally-friendly aluminum/zinc, with durable, corrosion-resistant, stainless steel links. 

 

Water Heater Pros Flush Kit For New Water Heaters Includes:

• 3/4" brass full-port ball valve with male hose thread, attached cap and chain for safety.

• 3/4" x 2-1/2” brass nipple, attached to drain valve.

• 7/8” x 3’ poly vinyl, easy view coupler hose with attached MHT (male hose thread adapter) & FHT (female hose thread adapter).

• Maintenance schedule stick-on label.

• Routine maintenance instruction sheet.

 

For Older Water Heaters ( 3-5 years old) comes with this easy to install anode rod:

Anode Rod made of aluminum and zinc, flexible links anode rod (4 section) segments connected with 304 stainless steel braided wire and stainless steel or copper couplers, anode link rod measures 3/4" diameter x 42" long, cut to fit any size water heater. Also good for helping minimize any "rotten egg smell"